Fixing The Cooling System On The Acura Legend Radiator Thermo We replace the radiator, perform a coolant system flush, and thermostat replacement on our 92 acura legend project. A large leak will usually result in coolant on the garage or driveway floor. 2. cracked radiator top where throttle cable bracket attaches to radiator all legends have this problem at one time. 3. if you have no leak in the system there is only one other way to get air in the system.
Fixing Acura Cooling System Auto Service Professional I've got a 95 acura legend with cooling issues. i recently replaced a cracked radiator and the thermostat while i was at it, but the coolant is boiling before the thermostat opens so i can't burp the system. the temperature gauge on the dash reads just under half, but the system is boiling over. Once fully warmed up, open the throttle and run the engine between 2 3000 rpms and you should be able to see the coolant moving in the top tank. keith march 12, 2012, 9:41pm 8. the coolant level may rise a little but not too much. if a lot of fluid overflows, that would indicate a clogged radiator. To remove the thermostat, you should : 1) start with a cool engine, 2) drain the coolant 3) disconnect upper radiator hose 4) unbolt thermostat housing. to install, reverse the process, but make sure you have a new gasket for the housing, and clean up the mating surfaces on both the housing and the engine. Remove the thermostat housing bolts, the housing and the thermostat. clean the gasket mounting surfaces. to install, use new gaskets and reverse the removal procedures; install the thermostat's spring end toward the engine. torque the housing bolts to 9 ft. lbs. (12 nm). refill and bleed the cooling system.
Diy Thermostat Acura Legend Forum To remove the thermostat, you should : 1) start with a cool engine, 2) drain the coolant 3) disconnect upper radiator hose 4) unbolt thermostat housing. to install, reverse the process, but make sure you have a new gasket for the housing, and clean up the mating surfaces on both the housing and the engine. Remove the thermostat housing bolts, the housing and the thermostat. clean the gasket mounting surfaces. to install, use new gaskets and reverse the removal procedures; install the thermostat's spring end toward the engine. torque the housing bolts to 9 ft. lbs. (12 nm). refill and bleed the cooling system. I have a 1991 acura legend 3.2. i have replaced the water pump, radiator, coolant sensor, thermostat. my car is still overheating and is not smoking, and fans are working properly. after a couple of minutes of starting my car its starts accelerating up and down by itself. Charlie. answered in 13 minutes by: mechanic for acura: eric. hi, thermostat is just below the throttle body: drain the cooling system and remove the lower radiator hose from the thermostat housing. remove the thermostat housing bolts, the housing and the thermostat. clean the gasket mounting surfaces.
Diy Thermostat Acura Legend Forum I have a 1991 acura legend 3.2. i have replaced the water pump, radiator, coolant sensor, thermostat. my car is still overheating and is not smoking, and fans are working properly. after a couple of minutes of starting my car its starts accelerating up and down by itself. Charlie. answered in 13 minutes by: mechanic for acura: eric. hi, thermostat is just below the throttle body: drain the cooling system and remove the lower radiator hose from the thermostat housing. remove the thermostat housing bolts, the housing and the thermostat. clean the gasket mounting surfaces.
No Heat How To Replace A Thermostat 1995 Acura Legend L 4 Door 3 6 V6
Comments are closed.